Shimano TL-BR003 hydraulic brake bleed cup (Y13000100)
Tuotekuvat ovat havainnollistavia. Alkuperäinen tuote voi vaihdella, joten katso tuotetiedot tuotekuvauksesta.
Hinta
€ 17.00
€ 18.80
Alennus € 1.80
Verkkokaupan hinta voi vaihdella kaupan hintojen mukaan.
Pistettä 
+17
Toimitusaika ja vaihtoehdot
-
2-4 päivää -
2-4 päivää -
2-4 päivää -
2-4 päivää -
2-4 päivää
Tuotteen Kuvaus
A cup used to bleed hydraulic bicycle brakes, suitable for Shimano brakes that use mineral oil. Above all, it is suitable for gravity ventilation, where the cup is placed with the handle at the highest point and the brake caliper at the lowest.
- Remove the brake pads and place a vent block between the pistons to prevent the pistons from coming loose.
- Remove the handle bleed screw.
- Screw the cup into place (make sure the O-ring of the screw was removed with the screw).
- Attach a suitable hose and reservoir for the brake caliper bleed screw.
- Fill the cup with mineral oil.
- Loosen the brake caliper bleed screw to allow new brake fluid to drain through the system.
- Pump the brake lever to drain the brake fluid from the lower end.
- Fill the cup if necessary to prevent air from entering the system.
- Finally, close the brake caliper bleed screw
- Pump a few more times to make sure the air bubbles have left the hose (you can even tap the hose).
- Remove the cup and screw in the bleed screw with the O-ring.
Contents
- cup, stopper and rack for the cup.
- Only suitable for mineral oils
